Manual for Advance 10T
allowed to exist. However, if therere only four or fewer partitions, users can follow
the system prompt and choose to install RecoveryEasy based on the previous disk
partitions. In this way, the original extension partitions will be changed to normal ones,
and probably the sequence of the partitions will be changed also, but the contents
contained in each partition will remain the same.
b. If choosing to install RecoveryEasy on an absolutely clear disk, the utility will delete all
the previous partitions.
c. The password is set as default setting qdiqdi after installing RecoveryEasy.
1.1 CREATE PAR
Function :
Creates a new partition.
Limitation:
When no disk space remains or 4 partitions already exist, this button is
disabled.
Steps
:
After pressing the CREATE PAR button.
a. The system will prompt whether users want to create a mirror partition for it or
not.
b. If answering Y, input the new partition size in Megabyte. Notice that the
maximum partition size that can be assigned is half of the left disk space, which
is also displayed in the status line. Another half is for the mirror partition. If
answering N, the whole disk space left can be assigned. See figure-2.
Note:
a. The system will prompt Insert system floppy, then reset when the first
partition on the first hard disk is created.
b. After using DOS6.xx boot disk to format C partition, the system should be reset in order
to access the partition.
c. In Windows system 1,048,576 bytes equal 1 Megabyte, while in RecoveryEasy 1,000,000
bytes equal 1 Megabyte, therefore a smaller size will be displayed in Windows system
compared with the size displayed in RecoveryEasy.
figure-2 Create Partition
Appendix
