QABA 370-033, Руководство пользователя

Страница: 6 / 17

3
4
Assembly Steps
IMPORTANT SUPPLEMENT TO INSTRUCTION MANUAL
After assembling any wheel to the axles, please check the gap
between the screw thread and the collapsible (refer to below
picture), if the gap is too big, please add two or three washers inside
the wheel, But after tightening the nut outside the wheel, please turn
the wheel by your finger to check if the wheel can run smoothly, this
is very important, because if the wheel can run smoothly, it is ok, but
if the nut press the wheel and the wheel can’t run smoothly, the
motor will be broken easily! Then you need to decrease one or two
washers to make sure the wheel can run smoothly!
GAP
Ø10
locknut
Rear
axle
Ø10
washer
Ø10
washer
Rear
wheel
Front
fender
Front
fork
M5x12 machine
screw
Rear
hubcap
Ø10 bushing
● Fit a Ø10 washer onto the rear axle from
Right side (standing at rear of the vehicle
body).
● Fit a Ø10 bushing(ring end first) onto the
rear axle.
● Fit a rear wheel onto the rear axle, keep it
match with the bushing.
● Fit a Ø10 washer onto the rear axle.
● Fit a Ø10 locknut to the end of the rear
axle, and tighten with a spanner. DO NOT
over tighten.
● Insert the tabs on the rear hubcap into
slots in the rear wheel.
● Fit the front fender to the front fork.
● Insert a M5x12 machine screw through the
front fender and into the front fork, tighten the
screw with a screwdriver.
● Repeat for the other side.