QT‐AD10A15Transmitter Family
7
Features
Performance
20 Hz to 20 kHz range with flat frequency response
Automatic input staging optimizes gain setting
AES 256‐bit encryption‐enabled for secure transmission
>120 dB dynamic range
100 meter (300 feet) line‐of‐sight operating range
Selectable modulation modes optimize performance for spectral efficiency
o
Standard – optimal coverage, low latency
o
High density – dramatic increase in max system channel count
Built‐in tone generator and RF markers to facilitate walk‐testing
Switchable Power Levels = 2/10/20mW (region dependent)
Design
Single pin Lemo audio connector
Rugged metal construction
Flexible ¼ wave antenna
Working with the AD10
Out‐of‐the‐Box Setup
Ensure the QT‐AD10A15 has a sufficient charge level by first connecting a micro USB charger and
check for charge levelwith a QG‐N3 gateway or QG‐H2MicCommander remote that the charge level is
adequate for your intended use.
Storage Mode
When the AD10 Transmitter is in Storage mode the transmitter will be completely off and will not
respond to any commands from the QG‐H1 remote or QG‐N3 gateway. If the transmitter was set to
Storage mode , the only way to bring it out of storage mode is to connect the Transmitter to a usb
charger to bring it out of storage mode.
If it was in this mode, as opposed to a battery run down condition, when you insert the charger it will
wake up and report the battery level via the <Charge> LED. Depending on the charge level and how
long it’s been in storage it may be ready to use or may require some time on the charger if it’s below
your required battery level.
