QT‐AD10A15Transmitter Family
10
Groupis the group number (1‐16) to which the transmitter belongs, allowing it to be controlled
with group commands (see
Group Commands
below). To change the group that the
transmitter belongs to, select the transmitter, then the add it to the desired Group number.
From here the number can be adjusted using the “UP/DOWN” arrows. Once satisfied, press
“ENTER” or “BACK” button and select “Save” when prompted.
RF Poweris the power setting of the RF output of the transmitter. This can be adjusted by
bringing up the menu below and selecting the desired value. A lower power level will conserve
battery life.
2.4 GHz Chthe RCAS control channel default is 25, change this on the transmitter only if you
are having control issues that can be seen when you have completed a 2.4GHz Spectrum scan.
See
Device Configuration
, the
2.4 GHz Telemetry
section below for detailed instructions.
Storage Mode, Will configure the QT‐AD10 to it’s off mode. This means none of the functions
of the unit are running, and the unit is in effect off. To return the QT‐AD10A15 to standby
mode the on/off button needs to be pressed for 3 seconds or connected to a charger.
Reboot, Will remotely cause the transmitter to do a power on reset. This will return the
transmitter to a known state of operation.
