Wireless USB A/V Adapter Set User Guide
www.q-waves.com
Page 33
Problem/Question
Symptoms
Solution
Problems in establishing
connection with Device
(red) icon in System
Tray
To check if a device is connected, right click the
System Tray icon and select
Wireless USB
Manager
to view the list of available devices and
to see the green
Connected
icon next to the
device name of the newly established connection
- Green System Tray icon
does not light up
to indicate that a connection has been established,
OR
- The Device is not listed in the
Wireless USB
Manager
screen
Power not connected to Device:
ensure that the correct power supply is
connected to the device side.
Device Adapter requires restart:
detach and re-attach the Device
Adapter from the Table Adapter to
restart the hardware.
Wireless Device is out of range:
if
you experience frequent Wireless link
disconnection, the Wireless Device
may be out of range –the solution is to
bring the Wireless Device closer to the
Wireless USB Host.
Device Adapter requires pairing:
if you are adding a Device Adapter that
was not part of a set, or if you are
connecting to a new unrecognized
Host, you may need to
perform the
Pairing procedure see
Appendix B: Pairing Procedure.
Channel busy message
displays when I try to
change the channel
Note
: manual channel
selection may be restricted
by local communication
regulation laws.
External radio interference may exist close to the
PC/device
Channel selection SW may have failed
Another wireless system may be in use
in proximity to the PC or device
environment, and may cause temporary
interference to the wireless USB
system. Try to select a different
channel (where applicable - local
regulatory restrictions may apply).
Close the message box, detach the PC
Adapter from your PC and re-attach it.
If the message displays again, try to
change the channel again.
Problems with Pairing
see also - Appendix B:
Pairing Procedure
The Pairing procedure does not result in the
confirmation screen "WIRELESS USB device has
been paired", or results in an error message.
Detach and re-attach Device Adapter
OR
Re-attach PC Adapter, then attach
Device Adapter
OR
Detach all Adapters, restart PC and try
Pairing again.
