q-Tech QSW-9010, Руководство по настройке CLI

Страница: 15 / 101

User Manual
1. GPON properties 15
www.qtech.ru
OLT# zlog upload tftp 192.168.1.111
4. When the command execution succeed, in the TFTP server folder, you can see diag.tar.gz
compressed package files, including unos.log and other diagnostic information.
1.7.5. Configuration Saving and Restore
OLT supports the saving and restore of system configuration, saves the configuration of the system
in the main.conf folder, and saves it to the local computer and restore through TFTP. When the
equipment is deployed or the system is upgraded, it is recommended that the configuration file be
saved to the computer for emergency recovery.
Upload Steps:
1. Open the TFTP server locally, set up the corresponding work folder, and ensure that the local
computer can access the OLT device via the IP address with the inside / outside management;
2. When you implement backup of configuration commands, you need to enter the following
command in administrator mode. The configuration file will be uploaded to the working
folder of the TFTP software settings, and the file name is main.conf;
OLT#, TFTP, config, put, 192.168.1.111
Note:
192.168.1.111 is the IP address of the network card used to connect the OLT management port on
the computer.
3. When you need to restore the configuration command, change the original configuration file
to main.conf and save it in the download folder of the TFTP server settings. The following
command restores the configuration file from the computer to the OLT.
OLT # tftp config get 192.168.1.111
1.7.6. View current configuration
OLT supports to view the the configuration on the current equipment under any node.
OLT# show running-config
Note:
the ONU sequence of all configurations is shown as the order of ONU authentication registration.
1.8. OLT Software Upgrade
Upgrade the OLT software in two ways, FTP and TFTP.
The update steps are as follows:
1. Connect the computer to the in-band / out-band management port of the OLT.