Step 1: Input 0,1,2,3 continuously, a long beep will be heard, green
indicator flash once, red sensor indicator flashes. (figure 2-17)
2.6
How to unlock with enrolled fingerprint?
green indicator
flash once
Input wake-up code,e.g.0,1,2,3
Step 2: Put an enrolled finger onto the sensor immediately while the
red sensor indicator is flashing. Motor driving will be heard. During
any steps of authentication, if the red indicator flashes after moving
away the finger, a second authentication will be needed. Repeat the
above steps. (figure 2-18)
Put an enrolled finger onto
the sensor
Step 3: Move away the finger and rotate the handle to unlock the door,
5 seconds later the door will be locked again automatically.(figure 2-19)
How to delete enrolled fingerprints?
2.7
Step 1: Press and hold digit
3
for about 6 seconds till you hear a
short beep, as shown in 2-20.
Press and hold digit
3
for about 6 seconds
Step 2: Input fingerprint enrollment code continuously (the default
fingerprint enrollment code is 2,1,3,2,1,3,2,1,3,2,1, if you have
changed it, then input the new one), a beep will be heard, a second
beep will follow in 5 seconds, the green indicator flashes, which shows
the successful operation. (Figure 2-21)
NOTE: To enroll the same finger twice (two templates for one
fingerprint) is recommended.
Step 3: Repeat above two steps for more enrollments.
Input the rest 10
digits of fingerprint
enrollment code
The green indicator
flashes
Put your finger
onto the sensor
The green indicator
flashes,follows 2
beeps
H
tt
p
:/
/w
w
w
.q
-s
e
e
.c
o
m
LOCK
