Pyxis SP-395 HST, Руководство по эксплуатации

Страница: 6 / 13

6
2. Starting SP-395
2.1. Battery Installation
The SP-395 is powered by a 9-volt alkaline battery. Do not use rechargeable nickel cadmium (NiCad) or
lithium batteries. A typical 9V battery lasts for two months and enables about 3000 measurements.
When the battery capacity is critically low, the SP-395 will display a LOW BATTERY warning for 5
seconds and then automatically turn off.
Replace the battery to resume operation of the SP-395 after the battery warning. The SP-395 will
automatically turn on in the measurement mode after new battery installation.
The SP-395 battery compartment, shown in Figure 2, is on the back side of the instrument.
Install battery as follows:
1. Remove the battery compartment cover by loosening two screws.
2. Make sure that the smaller circular terminal (positive) of the battery is aligned with the
hexagonal socket (positive) of the battery holder and the hexagonal socket (negative) of the
battery with the circular terminal of the holder. Snap the battery firmly into the battery holder.
3. Replace the battery compartment cover, making sure that the sealing O-ring is lying flat on the
battery holder. To prevent the SP-395 from accidently being turned on due to vibration, please
firmly tighten the two screws.