MUX2
| User Manual
© PyroScience GmbH
12
4. Choose the right mains plug
according to your country, and connect
it to the mains supply. Now the green
LED on on both motor housings of the
Micromanipulator
MUX2
should light
up, indicating proper power supply.
5. Turn the control knobs in order to move
the motors for the x- or z-axis. The motor
speed is proportional to the turning angle. In
order to stop again, turn the knobs back into
its centre position. The motor will
automatically stop if it reaches either end of
the slide.
After power-up, both motor slides have to be
moved to the very top-position (z-axis) and
very left-position (x-axis). Otherwise they
cannot be moved over the full range of the
slides
.
IMPORTANT:
Each time the power supply is switched off and on, the motor has
to be "homed", otherwise it will not be possible to move over the full range.
Turn the control knob counter-clockwise, and let the motor move upwards until
it stops at the upper limit. Now the motor can be moved along the full distance
of the slide.
