Pyronix BUMBT!8, Руководство по установке

Страница: 19 / 35

Rins 181 Issue7 Page 19
11 PROGRAMMING
11.1 Factory Defaults
The panel is preprogrammed to the factory settings shown below.
Master User code : 1234 (0000-9999)
Limited User code : 5678 (0000-9999)
Engineer code : 9999 (0000-9999)
Bell timer : 20 minutes (programmable 2 to 20 mins)
Entry : 30 seconds (programmable 2 to 255 secs)
Exit : 30 seconds (programmable 2 to 255 secs)
Event log : Engineer reset of log
Downloading access code : 1234
Group reporting : Group1=1, Group2=1, Group3=1
Dial in : Enabled
Zones : End Of Line Resistor
The following key applies to the table below:
Entry / Exit
=
E
Access =
A
Immediate =
I
The zone types are factory set as follows.
Zone
Number
1 2 3 4 5 6 7 8
Set A
E a I I I I I I
Set B
e a I I I I I I
Set C
e a I I I I I I
Set D
e a I I I I I i
11.2 Entering Engineer Mode
Enter
The fault LED will flash when the Atlas 8 is in Engineer mode.
The day LED will flash during programming of any of the functions.
Whilst in Engineer mode, you are able to remove any covers without creating a tamper alarm.
11.3 Setting Volume Control (Extension speaker only)
This volume is controlled via the adjustable volume pot on the main processor board.
1. Remove lid.
2. Set volume pot to desired volume
3. Depress a number digit on the keypad to check desired volume has been reached.
4. Replace cover.
In an alarm condition the volume control is overridden and the speakers will operate at full volume.
Note: each RKP has its own volume control pot.
11.4 Resetting the Non Volatile Memory (NVM) to Factory Settings
The panel may be programmed as user NVM reset or engineer only NVM reset.
Engineer Power Up NVM Reset
If the panel is configured by the engineer to allow the reset of the NVM back to factory settings by powering up the
system with the NVM reset pins shorted together.
Locate the NVM reset pins on the PCB, using the link pin provided connect the two pins together. Power down the
system (mains and battery). Restore power and remove the link. The system is now back to factory default settings.
Engineer Only NVM Reset
Enter the engineer mode. Use the link supplied to connect the NVM reset pins together and enter on the
key pad. The system is now back to factory default settings.