Pyramid PR-532T, Инструкция по эксплуатации

Страница: 3 / 4

CONNECTIONS
CD TUNER EQ TAPE
TUNER
INTEGRATED CIRCUIT
AC 220~230V 50Hz
75
Ω
FM
AM
Loop
ANTENNA
OUTPUT
RISK OF ELECTRIC SHOCK
DO NOT OPEN
FM Antenna (75 )
Ω
AM Loop Antenna
PHONO CD AUX VIDEO TUNER REC PLAY
TAPE
PLAY REC
EQ
L
R
* Instructions and requirements indicated may vary to some extent depending on sales area, local law and regulations.
Connection precautions
* When connecting or re-locating the unit, be sure to turn the power off or disconnect the power cable.
* Check the left and right channels and align them correctly (L to left and R to right.)
Connections to amplifier
The supplied pin-plug cables should be used for connection between the unit’s rear panel OUTPUT terminals and your
amplifier’s TUNER terminals. Make sure not to confuse the left and right cables in connection.
FM antenna
Indoor T-shaped FM antenna
The T-shaped antenna included with the unit is meant for temporary use until an outdoor FM antenna is set up. Connect it to
the FM 300 Antenna terminals and open the arm ends to form a “T” shape. While listening to a broadcast, hold the stretched
ends and move around until it is facing in the direction in which the signals come in strongest, then attach to wall or ceiling.
FM antenna connection
Use the FM 300-ohms terminals when connecting the T-shaped FM feeder antenna supplied or a 300-ohms lead-in cable
from an outdoor antenna. Use the FM 75-ohms terminals when connecting a 75-ohms coaxial cable from an outdoor
antenna.
AM loop antenna connection
Connect the cord of the accessory AM loop antenna to the AM LOOP antenna terminals, and attach it to the accessory
antenna holder.
Attach antenna holder to a wall with the range of the loop antenna cord. When tuning into AM (MW, LW) stations, move
the antenna to the left or right and set it in the direction which yields the optimum reception.
* AM (MW, LW) reception is not possible with the loop antenna detached. Even if n outdoor AM antenna is erected, keep
this loop antenna in place.
* Do not bring the power cord or the speaker cords near the loop antenna since noise will be generated.
* Do not bring the loop antenna near the display, otherwise it will affect the reception.