Press "SELECT" button to switch
FM channels & POWER.
SELECT
FM CHANNEL
FM CHANNEL LED
(
4 channel select)
POWER
LED
FM MODULATOR SECTION
Press cable button that if you are using FM Modulation to
provide audio signal from the tuner to you car radio, applying
the unite function will also mute the audio portion of the signal
delivered by the transmitter but not the tuner's output carrier
signal providing A/V audio to your car radio.
Transmitting audio to your car radio
This tuner system is able to transmit the audio signal to your
car radio in the FM Radio spectrum. By tuning your radio to a
corresponding channel, you can listen to the audio from your
program source. This function is particularly important when
installing in car whose radio lacks AUX line level inputs.
To use this system turn your car radio from
,
,
, and
. for 4
channels. You shall be able to hear your AV audio broadcast
through your car radio system.
[email protected] 87.9@Mhz 88.3@Mhz
88.7@Mhz
《
12
》
《
11
》
26. VOL+: Volume up the monitor
27. VOL-: Volume down the Monitor
28. MUTE: Shut the sound OFF
29. MENU: Enter monitor OSD Menu
30. EXIT: Exit OSD menu select
31. FORMAT: Switch NTSC/PAL
32. V-Chip(Option): Enter V-Chip setup to select a rating level.
33. C.C (Option): Close caption
34. CH+: Adjust channel up
35. CH-: Adjust channel down
+- 30 Degree
Appendix
Changing the New Battery in Remote Control
1. Push the battery case button to wards the right.
(As shown # 1 in below
figure)
2. Pull the battery case away from the remote control.
(
As shown
# 2 in below figure) Change
a new battery.
Cassette Button
1
2 Battery
Using the Remote Control
1.Point the remote control towards the IR
sensor in front of the monitor housing.
2.Operation angle: IR remote control will
work about 30 degree in each direction
from the IR sensor of the monitor housing.
