9
• ORANGE/GRAY WIRE - Hood trigger (-).
Connect to supplied hood pin switch that
shows ground when the hood is open.
Module Connectors
2-Pin Large Black Connector:
Plug-in
connector for valet switch. Mount switch in an
area easily accessible from the driver’s position.
2-Pin Small Black Connector:
Plug-in
connector for LED. Mount LED in an area
where it may be easily seen from either side of
the vehicle.
4-Pin Connector:
Plug-in connector for
extended range receiver.
2-Pin White Connector:
Plug-in connector for
door locks.
• BLUE WIRE - Unlock output (-).
• GREEN WIRE - Lock output (-).
6-Pin Starter Harness
• BLUE WIRE - Main accessory output (+).
12V output for heater and/or air conditioning
system. For cars with more than one accessory
wire add a relay(s) to power the extra
accessory wire(s) or set dip switch #3 to ON
and use the GREEN wire for second accessory.
• YELLOW WIRE - Main ignition output (+).
Connect to the main ignition wire that switches
+12 V and does not drop out during cranking.
• GREEN WIRE - Second ignition output (+).
Connect to the wire that sw12V and
does not drop out during cranking. This wire
may be optionally set for use as a second
accessory wire or second starter wire.
• BLACK/YELLOW WIRE (small) - Starter
anti-grind input from key switch (+). If the
optional anti-grind feature is desired, cut the
vehicle’s starter wire and connect the small
Black/Yellow wire to the side coming from the
keyswitch. Connect the large Black/Yellow wire
to the side going out to the starter.
• BLACK/YELLOW WIRE (large) - Start output
(+). Connect to the vehicle’s starter wire. If
using the optional anti-grind feature, connect as
explanined under small Black/Yellow wire
description.
• RED WIRE - Main power input (+). Using the
supplied inline fuse holder, connect directly to
the vehicle’s battery or alternate power source
with a minimum 30 Amp supply.
SYSTEM PROGRAMMING
Entering Programming
To enter System Programming
1. Turn on ignition.
2. Within 5 seconds, press valet the proper
number of times for the desired mode:
5 presses = Start Programming
10 presses = Convenience Programming
• The LED will flash to indicate
programming mode entered:
5 chirps = Start Mode
10 chirps = Convenience Mode
3. Press the valet switch the number times
equal to the Feature you want to change.
• The LED will flash each time the valet
switch is pressed. A long flash is equal to
5 presses. (Example: step 7 = 1 long flash
and 2 short flashes.)
4. Within 5 seconds, press the transmitter
button corresponding to the desired
operating mode for that Feature.
• The LED will flash either 1, 2, 3, or 4 times
to indicate the button setting.
5. Repeat steps 3 and 4 to change additional
features.
6. Turn off ignition to save changes.
Default Reset
S series.qxd 9/24/2004 11:08 AM Page 9
