Installation and Connection:
1.
Please disconnect your car battery.
2.
In the contents of your box there should be a wire harness that plugs into the male
receiving connection cable of your mirror mounted monitor/camera. We are not
going to plug it into to your monitor yet. There should be yellow, red, black & green
wires coming from the small plastic square at the end of the wiring harness cable.
3.
Attach the black wire to your vehicles metal body or any available ground wire.
4.
Attach the red wire to any available ignition controlled positive 12V power source,
mostly likely located at the fuse box.
5.
Attach the yellow wire to any available positive 12V power source that is always live
and is not
6.
Connect the green wire to the positive wire going to your reverse tail lights so that
the monitor will receive a 12V signal from this wire when the car is put in reverse.
controlled by your ignition, mostly likely located at the fuse box.
7.
Attach the monitor/front view camera to your rear view mirror using the slide
clamps in the rear of the monitor.
8.
Then plug the cameras male plastic cable into the female receiving connection at the
other end of the monitor wiring harness cable with the small black plastic square
that you just wired to your automobile.
9.
Now we will decide how to mount your rear view camera. You have two options.
You can use the mounting bracket (included) with two screw holes as pictured.
Or you can use the hole saw (included) and mount as pictured.
