3
Assembly
Assembly is easy and requires no special tools.
1.
Align the plastic trapeziform raised part on the handle, with the trapeziform lower
groove at the control box bottom (Figure.1).push the two parts tightly.
Figure.1
2.
Align the threaded bolts at the handle bottom, with the knobs under the control
box, lock it with the bolts(Figure.2).
Figure.2
3.
Turn the stem’s lock nut clockwise until it loosens, lengthen or shorten the stem so
when you stand upright with your detector in your hand, the search coil is level
with and about 1/2 inch above the ground with your arm relaxed at your
side.( Figure.3).
Figure.3
4.
Loosen the knobs at the search coil’s end, then adjust the search coil to the desired
angle, let the search coil be parallel with the ground. Be sure the search coil is
attached properly (long end facing front) (Figure.4).
