PYM-6
Owner’s Manual
- 3
d
d
er
o
DECK
T.
E LINE.
3.MIX BUS CONNECTION
You can control up to 12 individual inputs with two independent
master controls by connecting two PYM-6 microphone mixers. To
prevent hum and other noise, connect a phono plug-to phono plug
shield cable between the MIX BUS jacks of both mixers.
Connecting the AUX OUTPUT
Both the AUX OUT 1/4" phone and AUX OUT RCA jacks are
unbalanced, high-impedance, high level outputs. To provide this
as input to an audio devise (such as an amplifier, tape deck, or
another mixcer), connect either jack to an amplifier or tape deck's
auxiliary high-level (0.1-2.0 volts) input terminals.
Cassette Deck
Main Amplifier
the
put
er
e's
Cassette Deck
Mixer
4.CONNECTING AC OUTLET
There is one supplied unswitched AC OUTLET (MAX 300W) which
allow the electrical hook up of other unit.
MIXING THE INPUTS
Set the MIC 1, MIC 2, MIC 3, MIC 4, MIC 5, and MIC 6/AUX mixing
controls to approximately halfway between MIN and MAX, then
adjust MASTER unitl you get an average rading of 0 on the LED
meter.
Note:The LED meter indicates the total level of all the input
sources being mixed.
To decrease or increase the mixing level of any microphone or
the auxiliary input source, turn its associated mixing control
toward MIN or MAX as desired.
To increase the overall volume, adjust the output amplifier's
volume control.
USING THE CH 6 MIC/AUX SWITCH
To mix in the audio input source connected to the AUX IN jack,
set CH 6 MIC/AUX on the back of the PYM-6 to AUX.
To mix in the microphone connected to either of the INPUT 6
microphone jacks, set CH 6 MIC/AUX to MIC.
CD Player
Cassette Deck
OR
1/4 Inch Plug Mic
3 Pin XLR Mic
