PXM PX206, Руководство пользователя, Страница: 6 / 8

4
6.3. PX206 REACTION TO DMX SIGNAL INTERRUPTION
6.1. DMX ADDRESS SETTING
This feature is used not only to protect the installation from DMX signal interruption, but also to
control the outputs without the external controller. After the feature is programmed, when the
DMX signal is not present, the module will realize the selected function independently. When the
DMX signal is connected again, the module stops playing the function and starts working
according to the commands transmitted through the DMX line.
With the PX206 you can choose one from the following options: all channels ON or OFF, 4 built-in
programs and 1 user-defined static scene. Make your choice from menu, so confirm
with the ENTER button and with displayed change it to required option with NEXT
button. With active go to the options submenu with ENTER and choose desired function
with NEXT/PREV buttons. Respectively:
1. All channels ON or OFF. With NEXT/PREV choose (all outputs set to ON) or
(all outputs set to OFF). Confirm decision with ENTER.
2. Built-in program selection. With NEXT/PREV choose one from 4 programs to
respectively. Confirm desired option with ENTER, the display will show (program
playback speed). Press ENTER and set suitable playback speed with NEXT/PREV. Make final
confirmation with ENTER.
DMX channel address you can set in two ways: group and individuall addressing.
1. Group addressing - :
NOTICE! Group adressingn automatically overwrites the previous individual addressing.
2. Individual addressing - :
It is possible to set individual address for each of PX206 channel. The same address may be
set to more then only one channel. With the active function press NEXT button to get
individual programming mode .Confirm the mode with ENTER button and will be
displayed, that means that PX206 is ready to get DMX address for the first channel Press
ENTER to display the current address and modify it with NEXT or PREV buttons (choose from
the range 1 to 512). Confirm your choice with ENTER and the next channel is ready to choose
with NEXT or PREV buttons. Repeat programming procedure for all channels you need
address modification as above.
Press ENTER to switch to the function .Press ENTER next time and the display will show
.Press button the third time to display the current DMX address for the first channel. With
the PREVIOUS or NEXT buttons select suitable value (from the range 1 to 504) and finally
press ENTER to confirm your selection. Making selection for the first channel will automatically
set consecutive addresses for the remaining 7 channels.
6.2. OUTPUTS INCLUSION OR EXCLUSION - DMX VALUE LEVEL
The output will be switched on when value of DMX signal will reach 141 or above.
The output will be switched off when value of DMX signal will reach 115 or below.