PXM PX206, Руководство пользователя, Страница: 5 / 8

3
6. PROGRAMMING
When you turn the module on, the display will show the software version number, and - after
approximately 2 seconds - PX206 is ready to start programming procedure, categorised to
2 divisions:
1. DMX address setting (all channels in sequence or individuall addressing, as “patching”)
2. Programming PX206 reaction to DMX signal interruption (to choose from: all channels
ON/OFF, 4 built-in programs with the speed programming, 1 static scene defined by user).
There are 4 buttons dedicated to realise PX206 programming: ENTER, ESC (Escape), NEXT
and PREV (Previous). Any programming level output is realised by pressing ESC button.
Finally the first channel address is diplayed.
4. DMX SIGNAL CONNECTION
PX206 must be connected to DMX line in serial mode, with no branches on DMX control cable.
That means that DMX line, from the signal source, must be connected to DMX IN pins of PX206
and later, directly from DMX OUT pins to the next device in DMX chain. If the PX206 is the last
DMX chain receiver there should be terminator (resistor 110 Ohm) mounted between "DMX+"
and "DMX-" pins of DMX OUT section.
CORRECT
110 Ohm
WRONG
5. DISPLAYED MESSAGES MEANING
DMX address setting for all channels concurrently.
Setting the individuall DMX addresses for each
channel.
DMX address - channel 2.
DMX address -channel 1.
etc. - DMX addresses for channels 3 to 7 (X=3 do 7).
DMX address channel 8.
DMX address for the first channel in concurrently
setting ALL.
PX206 programming for DMX control interruption (4
built-in programs or 1 scene).
All the outputs OFF (in case of DMX interruption).
All the outputs ON (in case of DMX interruption).
Built-in program no. 1 (in case of DMX
interruption).
Set channel output OFF for scene programming.
Set channel output ON for scene programming.
Built-in program no. 2 (in case of DMX
interruption).
Built-in program no. 3 (in case of DMX
interruption).
Built-in program no. 4 (in case of DMX
interruption).
etc. outputs 3 to 7 for scene programming.
Output 1 for scene programming.
Output 2 for scene programming.
Output 8 for scene programming.
Scene programming.
Program speed setting.
DMX-512 INPUT DMX-512 OUTPUT
DMX LINE
DMX-512 INPUT
TERMINATOR CONNECTION