3
The PX319 driver is designed to control LEDs. It has voltage of
12 -
48 V DC and a maximum
current-carrying capacity of 2 A. It is possible to set the driver output current according to
the
parameters of receivers LED.
PX319 can be controlled by the DMX signal (the device has a built-in DMX-512 receiver) or it can
work independently. DMX address is set manually via a DIP switch on the housing. The user also
has the ability to set one of the eight levels of brightness with which the LEDs will be triggered in
the absence of a DMX signal.
1. GENERAL DESCRIPTION
2. SAFETY CONDITIONS
PX319 is a device powered with safe voltage of
12 -
48 V DC; however, you should at all times
obey the safety conditions. It is necessary to observe the following rules:
1. The device can be connected to 12 - 48 V DC (stabilised voltage) with current-carrying capacity
compatible with technical data.
2. All the conductors should be protected against mechanical and thermal damage.
3. In case of damage to a conductor, it should be replaced with a conductor of the same technical
parameters.
4. Connection of DMX signal can be made with a shielded conductor only.
5. All repairs, connecting and disconnecting of cables can only be made with cut off power supply.
6. The device should be strictly protected against contact with water and other liquids.
7. All sudden shocks, particularly dropping, should be avoided.
8. The device cannot be turned on in places with humidity exceeding 90%.
9. The device cannot be used in places with temperature lower than +2°C or higher than +40°C.
10. Clean with damp cloth only.
Содержание Driver LED 1x2A/48V
Страница 1: ...MANUAL Driver LED 1x2A 48V PX319 R ...
