PXM Club 6p, Инструкция по эксплуатации

Страница: 4 / 10

4
2 4
3 1
DMX starting address = 19
DMX starting address = 13
DMX starting address = 7
DMX starting address = 1
1.
2. All devices have to be connected in series only, that is:
- the output of the controller to the first dimmer input,
- the output of the first dimmer to the input of the second one,
- the output of the second dimmer to the input of the third one,
etc.
3.
4.
5.
6. In the controlled dimmers the proper DMX addresses must be set, considering, that the Club 6p
controller attends to 24 channels. The exemplary DMX address settings for four 6-channel
dimmers are shown below.
To connect the devices application of the microphone cable is strictly recommended (two
strands in a shield).
To split the DMX line it is necessary to use the DMX SPLITTER (PX094).
In case of the great number of devices or long distances use the DMX REPEATER (PX097). It
is an amplifier of the DMX signal.
In the last device a terminator must be installed. It is a 120 Ohm resistor.
3. CONTROLLER AND DIMMERS CONNECTION
The Club 6p controller sends out the control signal in a DMX-512 standard. With this signal the
light dimmers that control the terminal devices (spotlights) are controlled. The proper operation of
the whole set requires setting the proper DMX addresses of the controlled dimmers and a correct
connection between the controller and all the dimmers, made with a signal cable.
The most important information about creating the proper connections of the controller and the
dimmers are given below:
LAST
DEVICE
RESISTOR
1 2
3
120 Ohm
PUSH
1 2
3
SHIELD
DMX -
DMX +
1. ground
2. DMX (-)
3. DMX (+)
PUSH
2 3 4 5 6 7 8 9
ON DIP
1
2 3 4 5 6 7 8 9
ON DIP
1
2 3 4 5 6 7 8 9
ON DIP
1
2 3 4 5 6 7 8 9
ON DIP
1