PVA 112-2190, Руководство по эксплуатации, Страница: 15 / 34

FCS300 Series Manual
Revision D /
June 2020
Page 15 of 34
Part Reference Numbers
•
FCS300
: Refer to Drawing #
112-2195
for part reference numbers.
•
FCS300-ES : Refer to Drawing # 112-2190 for part reference numbers.
•
FCS300-ES-ND : Refer to Drawing # 112-2398 for part reference numbers.
•
FCS300-ES-ND : Refer to Drawing # 612-9338-1 for part reference numbers.
Please refer to the part number reference key below when reviewing the operation
instructions.
Bracket Used Drawing and Valve Indicated
( ) Drawing #112-5955
FCS300-F
Drawing #112-2195
FCS300-R
{ } Drawing #112-2190 FCS300-ES
[ ] Drawing #612-9338-1 FCS300-ES-UF
< > Drawing #112-2398 FC300-ES-ND
Figure 10: Part Number Reference Key
Operation
1. Plumb up the valve as outlined above in the setup procedures.
2. Regulate the air pressure operating the valve between 60-100 psi.
3. Make sure that the valve is not aimed toward anyone. Cycle the valve several times.
When the valve is cycling, the piston can be heard hitting the micrometer
adjustment and the needle (1){1}[1]<3> can be seen going up and down in the center.
4. Adjust the atomizing air pressure regulator. Air should be felt flowing from the end
of the valve when the valve cycles open. If the valve is not cycling properly, refer to
the Troubleshooting section.
5. When the fluid delivery system is connected to the valve, pressurize the material to
be dispensed.
6. Cycle the valve open to purge. Fluid should begin to spray from the tip of the air cap,
continue cycling the valve until all air is removed from the fluid line and a steady
spray pattern of material can be seen.
7. Adjust the atomizing air pressure to achieve proper spray of material. This pressure
will vary due to the viscosity of the fluid.