Puzer Eeva, Руководство пользователя

Страница: 8 / 9

FEATURES OF THE PUZER EEVA CIRCUIT BOARD
1 - SOFT START
The start peak is limited with a TRIC relay, this way the start power is delivered to the motor with a delay of 1
second. The start voltage is significantly smaller and the stress of the fuses, network and motor decreases.
2 - LOW VOLTAGE LED AUTOPOLARITY *2
The green light in the machine of the pendant is always one when the voltage is connected.
(i.e. the plug is in the outlet)
3 - OPERATION HOUR COUNTER *3
By using EEPROM technology (erasable programmable ROM), the card registers two two types
of time, which can be checked by the user only by looking at two separate LEDs located in the
protective board of the circuit board.
a. Short time b. Total time
4 - SELF CHECK
When the mains cable is connected, the circuit board performs a
self check. When everything is ok,
the LED blinks quickly for a few seconds.
5 - SHUT OFF DELAY
The shut off has a two (2) second delay
so that the pipe work and hose are surely emptied
after the switch off.
6 - RESET/DEMO SWITCH *6
Performs the following operations:
*3 *6 *7
*2
TIME USED LED COLOUR MEANS OPERATION
15 hours Slow green blinking The vacuum cleaner has been
used 15 hours since the last
receipt
Change/check the dustbag and
press the receipt button for 5
seconds
0-399 hours Green Less than 400 operation hours
-
400 - 499 Orange Over 400 operation hours
-
Over 500 hours Red Over 500 operation hours
-
Function Operation Result
Test/demo Press and release the switch in less
than 5 seconds. The card performs a self check and
goes through all the phases of the
previous table (see table 1)
Partial reset Press the switch for over 5 seconds
when the motor is not running. The system will reset the 15 hours’
countdown and the blinking LED
(3) returns to the continuously on
mode.
Total reset Press the switch over 30 seconds
when the engine is running. The system reset the total time
calculation.
7 - AUTOMATIC FUSE*7
The circuit board is equipped with an automatic fuse, (the button with the text “circuit breaker”).
The reset takes place by pushing the button.
8