
1988-1998 CHEVY/GMC (2 & 4 DOOR) #90012/#90013
LIQUID SOLID BILLET DOOR HANDLE INSTRUCTION SHEET
Step 3
:
Remove plastic cover from the door handle and door lock area shown in figure B-3. Use a flat
head screw driver to pop the cover off there is six tabs that hold it in place.
If you have power locks
there will be wires you need to disconnect.
STOP
Step 4
:
Remove door panel by popping the plastic plugs out
(Fig. B-4) that holds the panel in place you may need to use a
screwdriver to get started. Once the plugs are all removed
you will need to pull your panel straight up and out. There is
a one inch lip that supports the panel shown in figure B-5.
C. Remove Factory Door Handle
Step 1
:
Remove two 10mm bolts there is one on the outside
of the door shown in figure C-1. The other bolt is located on
the inside of the door you can access this bolt through an
Fig. B-3
opening shown in figure C-2.
Note: At this time you should
apply masking tape around the handle to protect the paint.
Step 2:
Remove the top two of the star screws and loosen the
third. (Fig. C-3)
Step 3:
Your door handle should now be loose and you will be
able to remove the rods that are held in place by the door
handle. (Fig. C-4)
STOP
Step 3:
You will need your key to turn the lock so you can
remove the handle from the door. (Fig. C-5)
Fig. B-4
Fig. B-5
Fig. C-1
Fig. C-2
Fig. C-3
Fig. C-4