PURSUIT 3100 Offshore, Руководство пользователя

Страница: 46 / 142

3100 OFFSHORE
46
4.5 AC System
The AC system is fed by the shore power outlet or
by the optional generator. It is wired totally
separate from the 12-volt DC system and is
equipped with an on-board galvanic isolation
system. The shore power inlet breaker is located
in the cockpit below the shore power inlet plug.
This breaker protects the AC system between the
shore power inlet plug and the main AC panel. All
AC current is distributed to the AC accessories
through individual circuit breakers located in the
AC panel. The main breaker in the panel protects
the system from an overload and the reverse
polarity light indicates any problems due to an
improper shore power supply. All AC outlets in
the cabin are protected by ground fault interrupt-
ers to protect against electrical shock. A cord set
is provided to supply power from the shore power
outlet to the boat’s AC system.
TO REDUCE THE RISK OF ELECTRICAL SHOCK IN WET WEATHER, AVOID MAKING
CONTACT WITH THE SHORE CABLE OR MAKING A CONNECTION TO A LIVE SHORE
OUTLET. NEVER SPRAY WATER ON ELECTRICAL CABLES WHILE WASHING DOWN
DECKS.
TO REDUCE THE POSSIBILITY OF AN ELECTRICAL SHOCK, IT IS IMPORTANT THAT
THE AC GROUND SYSTEM IS FUNCTIONING PROPERLY AND THAT A PROPER CON-
NECTION EXISTS BETWEEN THE SHORE POWER CORD, THE SHORE POWER INLET,
THE BOAT BONDING SYSTEM AND THE OUTLET GROUND CIRCUITS. IF THERE IS
ANY DOUBT ABOUT THE INTEGRITY OF THE GROUND CIRCUIT, A QUALIFIED MA-
RINE ELECTRICIAN SHOULD BE CONTACTED IMMEDIATELY AND THE AC SHOULD BE
DISCONNECTED UNTIL THE NECESSARY REPAIRS ARE COMPLETED.
CONNECTING PROCEDURE FOR SHORE POWER CONNECTION
Turn the AC main breaker to the “OFF” position. If the dockside outlet includes a disconnect switch, turn
it to the “OFF” position also.
To avoid strain on the cable make sure it has more slack than the mooring lines. Dress the cable so that it cannot
be damaged by chafing between the boat and the dock. Make sure the cable does not come in contact with
the water. Then connect the cable in the boat plug inlet and the dockside outlet, making sure the connection
plug includes a three-prong plug with a ground wire. Tighten the lock rings on both the shore and the boat
connector plugs. Turn the dockside disconnect switch or circuit breaker to the “ON” position and check for
proper polarity. If reverse polarity has been achieved, the red polarity indicator in the AC panel will light.
If this should happen, make sure the main breaker on the panel is in the “OFF” position and turn the dock power
Shore Inlet and Breaker