PURSUIT 3100 Offshore, Руководство пользователя

Страница: 117 / 142

3100 OFFSHORE
117
potable water antifreeze poured into the tank through the deck waste pump-out fitting. After the antifreeze
has been added to the holding tank, open the overboard discharge valve and activate the macerator pump until
the antifreeze solution is visible at the discharge thru-hull.
Make sure you follow the marine toilet manufacturer's winterizing instructions exactly.
Air Conditioner
Disconnect and drain the air conditioner intake and discharge hoses. Remove all water from the sea strainer
and thru-hull fitting. Allow all water to drain from the system. A recommended alternative to the above-
mentioned procedure is the use of commercially available nontoxic, potable water system antifreeze. If
potable water antifreeze is used, drain the sea strainer and pour the mixture into a pail and put the raw water
line into the solution. Run the AC until the antifreeze solution is visible at the discharge fitting on the hull
side. The air conditioner components must be properly winterized by following winterizing procedures in
the air conditioner owner’s manual.
The air conditioning, engine control system, head, and steering systems have specific lay-up
requirements. Please refer to their owner’s manuals for recommended winterizing procedures.
Bilge
Coat all metal components, wire busses, and connector plugs in the bilge with a protecting oil. It is also
important to protect all strainers, seacocks and steering components. The bilge pumps and bilge pump lines
must be completely free of water and dried out when the boat is laid up for the winter in climates where freezing
occurs. Compartments in the bilge that will not drain completely should be pumped out and then sponged
until completely free of water. Dry the hull bilge and self-bailing cockpit troughs. Water freezing in these
areas could cause damage.
Hardtop and Radar Arch
It is imperative that all drain holes in the legs are open and that the legs are completely free of water. Remove
the canvas and thoroughly clean and store in a safe, dry place. Remove all electronics. Coat all wire connectors
and bus bars in the helm compartment with a protecting oil.
Clean the aluminum frame with soap and water and dry thoroughly. Apply an aluminum metal
protector to
the entire frame to reduce corrosion and pitting.
ALWAYS MAKE SURE THE LEG DRAIN HOLES ARE CLEAR WHEN THE BOAT IS LAID
UP FOR THE WINTER. WATER TRAPPED INSIDE THE HARDTOP OR RADAR ARCH LEGS
COULD FREEZE AND CAUSE THE LEGS TO SPLIT.
Tower (if installed)
It is imperative that all drain holes in the tower and hardtop legs are open and completely free of water. Tower
basket drains should be checked and clear of debris. Remove the tower sun shade, if installed, and belly band
or removable cushions and thoroughly clean and store in a safe, dry place. Remove all electronics. Coat all
wire connectors and bus bars in the helm compartment with a protecting oil. Cover the tower basket with a
tarp and secure it properly.
Clean the aluminum frame with soap and water and dry thoroughly. Apply an aluminum metal protector to
the entire frame to reduce corrosion and pitting.