PURSUIT 2870 Walkaround, Руководство пользователя

Страница: 98 / 140

2870 WALKAROUND
12-2
Holding Tank and Macerator Discharge Pump
The holding tank is located in the bilge. When the tank is full it must either be pumped out by an
approved waste dumping station through the waste deck fitting or be pumped overboard with the
optional macerator discharge pump, when legal to do so. When the macerator discharge pump
option is installed, the Y-valve is used to select the waste deck fitting or the overboard macerator
discharge pump.
To operate the macerator discharge pump, move the Y-valve handle
to the macerator pump-out position, open the ball valve at the
overboard discharge thru hull fitting. Then activate the macerator
switch located in the in the bilge near the Y-valve, on the port stringer,
until the tank is emptied. Turn the switch to “OFF” and close the
discharge ball valve when pumping is complete.
Note: The macerator discharge pump can only be run dry for a couple of seconds. Allowing
the macerator pump to run after the holding tank is empty will cause damage to the
pump.
Maintenance
The head should be cleaned and inspected for leaks regularly.
The holding tank should be pumped out and flushed as needed. Periodically add chemical to the
head to help control odor and to chemically break down the waste. See the manufacturer owner’s
manuals for additional operating and maintenance information.
THE HEAD AND MACERATOR DISCHARGE SYSTEM MUST BE PROPERLY WINTERIZED
BEFORE WINTER LAY-UP. SEE SECTION ON WINTERIZING.
12.2 Ice Box and Refrigerator
An ice box is installed as standard equipment. The ice box drains into the bilge and has a special
latch to secure the door when the boat is underway. Make sure the ice box door is properly secured
whenever the boat is moving.
A dual voltage refrigerator is supplied as optional equipment. This unit will operate on 110-volt
AC or 12-volt DC power. The refrigerator switches to 12-volt DC automatically when the AC
power is disconnected and the refrigerator breaker is activated on the cabin DC panel. When 110-
Y-Valve with Macerator