PURSUIT 2870 Walkaround, Руководство пользователя

Страница: 29 / 140

2870 WALKAROUND
Before leaving the dock, make sure that the tabs are in the
full “UP” position by holding the control in the bow up
position for ten (10) seconds.
Always establish the intended heading and cruise speed
before attempting to adjust the hull attitude with the trim
tabs. After stabilizing speed and direction, move the trim
tabs to achieve a level side to side running attitude being
careful not to over trim.
After depressing a trim tab switch, always wait a few
seconds for the change in the trim plane to take effect.
Avoid depressing the switch while awaiting the trim
plane reaction. By the time the effect is noticeable the
trim tab plane will have moved too far and thus the boat
will be in an overcompensated position.
When running at a speed that will result in the boat falling off plane, lowering the tabs slightly, bow
down, will improve the running angle and operating efficiency. Too much bow down tabs can
reduce operating efficiency and cause substantial steering and handling difficulties.
Be extremely careful when operating in a following sea. The effect of trim tabs is amplified under
such conditions. Steering and handling difficulties can result from improper trim tab usage,
particularly in a following sea. Always raise the tabs to the full bow up position in these conditions.
When running at high speeds be sure that the tabs are in the full “UP” position. Only enough
trim plane action should be used to compensate for any listing. Trim tabs are extremely sensitive
at high speeds. Adjust for this and be prepared to slow down if difficulties arise.
When running into a chop, a slight bow down attitude will improve the ride. Be careful not to over
trim. Handling difficulties may result.
2.8 Control Systems Maintenance
Control Maintenance
Periodic inspection of the control systems and all connections should be made. Signs of rust,
corrosion, wear, or other deterioration should immediately be serviced. Generally, periodic
lubrication of all moving parts and connections with a light waterproof grease is in order.
Lubrication should be performed as often as necessary to keep the system operating smoothly.
Control system adjustments may become necessary. If adjustments become necessary, see your
Pursuit dealer.
2-5
Trim Tab