PURSUIT 2270 CENTER CONSOLE, Руководство пользователя

Страница: 70 / 104

2270 CENTER CONSOLE
Console Cooler
9-4
open position and prevents it from opening too far. Always make sure the helm station clamps are
properly secured when the helm is closed.
If a T-top is installed, it must be designed with four legs that are bolted to the cockpit sole near the
front and rear sides of the center console. There are aluminum plates laminated in the cockpit sole
that can be drilled and tapped to secure the T-top leg bases. Both front and rear legs should also
have brackets that are thru bolted to the console just below the hinged helm section to provide
additional stiffening for the T-top. Avoid a T-top that is designed to mount only on the center
console because it will cause the excessive flexing to the console and cockpit sole which will result
in stress cracks and fractures in the fiberglass . If you have any questions about installing a T-top
on your boat, please contact your dealer or the Pursuit Customer Relations Department.
ALWAYS MAKE SURE THE HELM STATION CLAMPS ARE PROPERLY SECURED BEFORE
OPERATING OR TRAILERING YOUR BOAT. IF THE HELM STATION IS NOT PROPERLY
SECURED, IT COULD OPEN UNEXPECTEDLY AND DAMAGE THE BOAT OR CAUSE LOSS
OF CONTROL.
UNDER NO CIRCUMSTANCES SHOULD THE HELM BE OPENED WHEN THE ENGINE IS
RUNNING. IN SOME SITUATIONS IT IS POSSIBLE TO ACCIDENTALLY ENGAGE THE EN-
GINE SHIFT AND THROTTLE CONTROL INTO GEAR AS THE HELM IS OPENING. THIS
COULD RESULT IN LOSS OF CONTROL, DAMAGE TO THE BOAT, AND INJURY TO PAS-
SENGERS.
Console Cooler (Optional)
A molded insulated cooler is installed under the front seat
of the console. The cooler drains to the cockpit sole
through a fitting in the side of the console. The cooler
should be cleaned thoroughly after each use.