INSTALLATION INSTRUCTIONS
•
Check whether the specification of your cable is compatible with this
DC-DC charger. (See table on page 6)
•
This charger can be installed both horizontally and vertically.
•
Make sure that the charger is installed as close as possible to the battery you
are going to charge, and you also need to make sure that the areas is not susceptible
to moisture, water, dust or high temperatures.
•
Ensure that there is no heat source or flammable gas around the unit.
•
Anderson plug is recommended when this charger is installed on a caravan or a
camper (see picture below)
•
Twin core cable must be used between the start battery and the charger, and you
need to connect the common negative and common positive wires from the starter
battery to the input of the DC-DC in the appropriate positive and negative terminals.
•
It is highly recommended to install a 60 Amp circuit breaker (not included in this
package) that should be installed near the starter battery.
•
Check whether all connections are clean and tight.
Suggested fitment to vehicle only
Suggested fitment to vehicle with caravan
This charger can also be connected to a solar panel, see detailed wiring diagram at Page 5.
03
