The Electronic Control Unit controls the motors via the Remote.
The Control Unit has three LED lights (Fig 6) and one recessed button (Fig 6A).
When turning the Isolation Switch on, the Control Unit will perform a self-test automatically. All the LED’s
will illuminate for 0.2 seconds and then cease, which indicates the Control Unit is functioning correctly.
If there is a fault, the Control Unit LED’s will flash accordingly:
Green LED:
Will illuminate when the Remote is turned on. If the Remote is out of range the LED will flash.
(Maximum range of signal is 100 metres without obstruction)
Blue LED: Will illuminate when the temperature of the control unit exceeds its operational limit or when
battery voltage is too low or too high.
Red LED:
Will illuminate indicating the following errors;
•
Voltage too low <10V: LED will flash twice slowly.
•
Voltage too high >15V: LED will flash fast five times.
•
Electric current is too high (= or >120A) LED will constantly flash.
• Temperature is too high >80C: LED is will illuminate permanently
Reset Button: Used for pairing the Remote.
The Control unit will automatically turn off if no button on the Remote is pressed within 60 seconds or the
Power Mover is working constantly in one direction for longer than three minutes. This is a built in safety
feature to preserve battery power and prevent the Control Unit from overheating.
Page 10
ELECTRONIC CONTROL UNIT OPERATION:
ELECTRONIC CONTROL UNIT:
PAIRING THE REMOTE:
SeaGo™
is supplied by the factory with the Remote already paired to operate in single axle mode. Should
you ever need to replace a Remote or set it up to operate in Dual Axle mode, follow these instructions.
SINGLE AXLE MODE:
Switch on the Isolation Switch and the Control Unit LED’s will flash for ten seconds.
Using the Aerial press the Rest Button on the Control Unit and the Green LED will flash. Whilst the Green
LED is flashing press the Power Button on the Remote twice. The Green LED on the Control Unit will remain
on.
DUAL AXLE MODE:
For Dual Axle configurations repeat the foregoing process with the Remote for both
Control Units.
After completing these procedures the SeaGo™ will operate after pressing one of the directional buttons
Green LED
Blue LED
Red LED
A: Reser Button
Aerial
SGO130-1304 SeaGo User Manual vs2.indd 10
3/05/2013 3:48:13 PM
