(5).Please be sure to follow the steps of the engraving machine installation instructions
during installation. The installation may cause the machine to malfunction due to
incorrect installation by the user.
(6).If there is an y problem with the operation of the machine during the machine
debugging process, please contact the after-sales personnel for disposal. Do not
disassemble it without permission, so as to avoid danger;
(7).Do not plug or unplug the terminal at any time while powering on. At the same
time, please note that the interval between the power on and off of the device should be
above 15S. If you do not pay attention to the above problems, it may cause damage to
the control circuit.
2.2.Installation instructions
The machine can be installed by following the instructions below.
Step 1: Install the motor, and install the stepping motors of the three axes to the
corresponding shafts. The locking screws on the couplings are tightened with the
Allen key.
