16
Installation & Operation Manual
Copyright © Puretec Pty Ltd 2020
7. Placing an O-Ring on the new or
cleaned sleeve, leaving approx. 1 inch
from the end and Slide the Quartz
Sleeve into the top of the chamber
and carefully slide down through the
bottom opening of the chamber until
the o-ring sits on top of the chamber
as shown.
8. Place the bottom O-Ring on the Quartz Sleeve and screw the bottom Aluminium Nut
on to the chamber. Gently tap the sleeve on the top to ensure that it's sitting firmly
on the bottom Aluminium Nut and then screw the top Aluminium nut back on and
drop the spring into the quartz sleeve as shown.
9. Slowly insert UV lamp into chamber through the hole of the Aluminimum Nut at the
top of the chamber. Connect the lamp connector to the pins on the Lamp Socket. Do
not let go of the lamp until the lamp is securely connected to the socket.
Never touch the quartz (glass) and lamp surface as marks or fingerprints may
interfere with UV transmission. If lamp is soiled, please clean lamp with an alcohol
based cleaner.
10. Connect the four pins on the end of the lamp to the
socket in the white cap. Slowly insert UV lamp into the
top of the chamber. Connect the earthing wire to the
chamber and plug in the ballast power connector and
turn the power on.
To reset the count-down timer, press and hold the
silver button for 15 seconds until ‘reset’ is shown on
the screen and a single beep is heard. The display will
show 365 days and the green ‘on’ LED will be lit.
11. Restore the water supply and check the unit for
leaks. Turn on a downstream tap to let the water
flow through the unit for 2-3 minutes to release
any air and impurities from the system.Check the
unit again after 1 hour for leaks.
Note: For initial use, wait 3-5 minutes to allow
water to pass through the whole unit. Turn on a
downstream tap to let the water flow through
the unit for 2-3 minutes to release any air and
impurities from system.
Maintenance Procedure
VALVE
IN
OUT
1
2
3
valve
IN
OUT
10
mins
4
5
6
Replacing UV Lamp
7
8
Replacing UV Lamp
IN
OUT
O Ring
1
2
3
valve
IN
OUT
10
mins
4
5
6
Replacing UV Lamp
7
8
Replacing UV Lamp
IN
OUT
O Ring
Fig. 10
7
8
9
Replacing UV Lamp
valve
IN
OUT
3
O Ring
9
4
5
O Ring
valve
10
mins
4
5
6
7
8
9
Replacing UV Lamp
valve
IN
OUT
4
5
O Ring
O Ring
Fig. 9
Fig. 11
Содержание WU-UV Series
Страница 20: ......
