Puretec NTR-E3 Series, Руководство пользователя

Страница: 17 / 24

17 Copyright © Puretec Pty Ltd 2020 NTR-E3 User Guide
Replenishment of Salt Supply
The salt storage capacity of the brine tank is approximately 50 kg. During each regeneration a
small amount of salt is consumed, thus requiring periodic replenishment for a continuous supply
of softened water (the frequency and salt dosage level is dependent on the regeneration sched -
ule).
We recommend to maintain the salt level in the brine tank to 1/2 to 2/3 full. The water level in
the brine tank is maintained automatically and does not require manual intervention.
NOTE : The
water level is usually below the salt level & therefore cannot be seen (this is not a problem).
Always replenish salt before the supply is exhausted.
Note : No extra water is required when topping up the salt level.
Type of Salt to Use
Any type of water softener salt may be used, but for best results, we recommend using coarse
solar salt called "water softener salt" or alternatively "pool salt".
Brine Tank Clean-Out
To help prevent service problems the brine tank should be emptied and flushed out with a
garden hose, when dirt and other insolubles accumulate.
Clean out with a wet/dry vacuum. Then add approximately 15L of water and refill with salt.
Media Replacement
Resin ordering code: RMK-NTR40 for NTR40-E3.
Customer Service Helpline at 1300 140 140 (AU) and 0800 130 140 (NZ) for more details.
The nuts and caps are designed to be unscrewed or tightened by hand or with the special plastic
wrench. If necessary a pliers can be used to unscrew the nut or cap. Do not use a pipe wrench
to tighten or loosen nuts or caps. Do not place screwdriver in slots on caps and/or tap with a
hammer.
Replenishment of Salt Supply