11
Lighting.(See Figure 7)
a) Push in and turn control knob ‘A’ anti-clockwise to the PILOT position.
b) Hold knob ‘A’ in for several seconds to purge any air from the system.
c) With knob ‘A’ still depressed turn it from the "OFF" position to the "PILOT" position until
the pilot light ignites Continue to depress the control knob for a further 10-15 seconds.
Release the control knob, the pilot should stay alight. If the pilot flame goes out, repeat
the process, holding down the control knob for a slightly longer period.
d) Depress control knob ‘A’ slightly and turn anti-clockwise to the ON position. The main
burner will not operate until this is done. The main burner may light depending on the
position of Control Knob ‘B’.
e)
Manual Override for Remote Control Models.
Turn Control Knob ‘B’ anti-clockwise to increase the flame height and clockwise to
decrease the flame height.
Note; a loud clicking noise will be heard when Control Knob ‘B’ is turned manually. This
sound comes from the spring loaded dog clutch between the knob and the motor and can
be ignored.
Extinguishing
a)
Manual Override for Remote Control Models.
Turn Control Knob ‘B’ fully clockwise.
This will turn off the main burner leaving the pilot burner alight.
b) Turn Control Knob ‘B’ to the pilot position. This will also turn off the main burner leaving
the pilot burner alight.
c) To extinguish the pilot burner. Turn Control Knob ‘B’ to the off position.
Adjusting the Flame Height
using the Remote Control Handset (See Figure 8)
The remote control system fitted to the fire uses ultrasound to transmit the signals
between the handset and the fire. It will work best if the grill at the front of the handset is
pointed in the direction of the fire. To prevent inadvertent ignition of the fire the UP button
on the handset will not function unless the SMALL button is held down at the same time.
A loud clicking noise indicates that control knob ‘B’ has reached the end of its travel.
FIGURE 8
