Pure Water WATT'R TWIN, Инструкция для владельца и по установке

Страница: 12 / 22

Page 12
Connecting the Drinking Water System to the Hot Water Tank
1. Pull the Water Treatment drawer out about 5 inches.
2. Connect the silicone tube from the top of the boiling chamber to the (top) tube
of the condensing coil. Clamp the hose.
3. Connect the silicone tube from the (bottom) tube of the condensing coil to the
top of the storage tank. Clamp the hose.
4. Connect the 3 prong universal connector from the distiller to the one on the
hot water tank.
Connecting the WATT’R TWIN to the Existing Water Lines
1. Turn off the water supply.
2. Drain any lines that are needed.
3. Have a professional plumber connect the waterlines as in Figure 1 on
page 7. This configuration is designed so that the distiller and hot water
tank can be isolated for servicing.
4. Pressurize the lines, fill the hot water tank, check for leaks.
Connecting the Water Supply to the Water Treatment System
1. To connect the 1/4” polyethylene
tubing from the cold water line to the
raw water inlet on the distiller:
a) Turn the household water supply
off.
b) Install the saddle tapping valve
on the COLD water copper
tubing so the outlet is in a conve-
nient direction. See figure 6.
c) Tighten screws evenly. Brackets
should be parallel. Tighten firmly.
Do not over tighten.
d) Connect tubing to the saddle tapping valve outlet.
e) Cut a one foot piece of the 1/4” tubing off the end to
allow the strainer to be installed.
f) Install the tubing onto the strainer. See figure 7.
Make sure the tubing is inserted fully into the
strainer and the flow is in the correct direction.
Tighten the nut firmly.
Figure 6
Figure 7
FLOW