Pure Water PTSF-2510-10, Руководство пользователя

Страница: 24 / 31

Tech Support: 1-888-989-7873
PURE WATER TREATMENT, INC.
Page 24
Troubleshooting
PROBLEM CAUSE CORRECTION
1. System Fails to Backwash A. Electrical Service To Unit Has
been interrupted.
A. Assure Permanent Electrical Service.
(Check Fuse, Plug, Pull chain or Switch)
B. Timer is Defective B. Replace Timer.
C. Power Failure C. Reset Time of Day.
2. Hard Water A. Bypass Valve is open. A. Close Bypass Valve.
B. Hot Water Tank Hardness. B. Repeat Flushings of the Hot Water Tank
is required.
C. Leak At Distributor Tube. C. Make Sure Distributor Tube is Not
Cracked. Check “O” Ring and Tube
Pilot.
D. Internal Valve Leak. D. Replace Seals and Spacers and/or Piston.
3. Loss of Water Pressure A. Iron Buildup in Line to Water
Conditioner. A. Clean Line to Water Conditioner
B. Iron Buildup in Water Conditioner B. Clean Control and Add Mineral Cleaner
to Mineral Bed. Increase Frequency of
Regeneration.
C. Inlet of Control Plugged Due to
foreign material broken loose from
pipes by recent work done on
plumbing system. C. Remove Piston and Clean Control.
4. Loss of Mineral Through
Drain Line. A. Air in Water System. A. Assure that Well System has Proper Air
Eliminator Control. Check for Dry Well
Condition.
5. Iron in Conditioned Water. A. Fouled Mineral Bed. A. Check Backwash, Brine Increase
Backwash Time.
8. Control Cycles
Continuously. A. Broken or Shortened Switch. A. Determine if Switch or Timer is Faulty
and replace it, or Replace Complete
Power Head.
9. Drain Flows Continuously. A. Valve is not Programming
Correctly.
A. Check Timer Program and Positioning
of Control. Replace Power Head
Assembly if not Positioning Properly.
B. Foreign Material in Control. B. Remove Power Head Assembly and
Inspect Bore. Remove Foreign Material
and Check control in Various
Regeneration Positions.
C. Internal Control Leak. C. Replace Seals and Piston Assembly.