Pure Water Mega Classic, Руководство оператора

Страница: 13 / 24

Mega-Classic Owners Manual page 13
8. Plug power cord into the machine and plug the
distiller into the power supply.
9. Turn the main power switch ON.
10. Open the faucet for 15 to 20 seconds ensuring
there is a steady stream of water, then close the
faucet.
Caution: Do not consume this solution.
11. Check water line for leaks. Tighten where
required.
Caution: If a leak is present, the pump may start automatically.
12. Allow the solution to remain in the system for 10-15 minutes.
13. Open the faucet and pump the remaining water from the storage tank. When the
pump shuts off, press the “PUMP OVERRIDE” switch until no water is present. See
figure 4a. Close the faucet.
14. Turn the function switch to DISTILL and the fan switch to STERILIZE. The fan will
shut off. See figure 4a.
15. Allow to steam sterilize for 45 minutes to 1 hour.
CAUTION: For proper sterilization, unit must run for at least 45 minutes, but
longer than 1 hour may harm the distiller.
16. Switch the main power to OFF. Unplug the distiller from the power supply.
17. Remove the top, right vented panel and the storage tank lid.
18. Pour the remaining 2 1/2 gallons of distilled water into the storage tank.
19. Replace the storage tank lid and vented panel.
20. Install the carbon filter.
20.a At a location close to the Mega-Classic, install the post filter bracket using the
tape installed on the bracket, or use a nail or a screw to affix to a wall.
20.b Place the post filter into the bracket and ensure it is secure.
20.c From the existing, distilled water line, cut the desired length of tubing to run
from the back of the machine to the filter. Insert the tubing from the back of
the machine to the inlet on the post filter. Insert the tubing from the faucet to
the outlet of the post filter. Press in firmly. Pull to test.
21. Plug the unit into the power source and turn the main power switch ON.
22. Open faucet and pump out water from the storage tank until the pump shuts off.
DO NOT CONSUME THIS SOLUTION.
Caution: Do not install
carbon filter until
solution is completely
drained.
Figure 4a