solo 250 manual_last revision_en.doc
6/16
5-PIN AND 3-PIN CONVERSION
SOLO 250 uses 3-pin XLR plug / socket. If your controller uses 5-pin XLR plug / socket, you should
convert 5-pin plug / socket into 3-pin socket / plug as shown below.
DMX TERMINATOR
In the Controller mode or Master/Slave mode, at the last fixture in the chain, the DMX output has to be
connected with a DMX terminator. Which prevents electrical noise from disturbing and corrupting the
DMX control signals.
The DMX terminator is simply an XLR connector with a 120
Ω
(ohm) resistor connected across pins 2
and 3, which is then plugged into the output socket on the last projector in the chain. The connections
are illustrated below.
To browse through the various Setup Options, press the FUNC button consecutively. There are 7
option codes (1~7), and each code has a specific function. The functions provided are listed in the
following table.
SETUP OPTIONS
CODE
CHOICE
FUNCTION
Y
Reverse Tilt enable - Tilt is reversed
1
N
Reverse Tilt disable - Tilt is normal
Y
Reverse Pan enable - Pan is reversed
2
N
Reverse Pan disable-Pan is normal
3
/
Not used
Y
Automatic programme (effect 1) enable
5
N
Automatic programme (effect 1) disable
4
Y
5
Y
Automatic programme (effect 2) enable
4
N
5
Y or N
Automatic programme (effect 2) disable
Y
16bit Pan/Tilt movement resolution enable
6
N
16bit Pan/Tilt movement resolution disable
Y
Movement of Master is different from slaves
7
N
Movement of Master is the same with slaves
Once you have selected the desired operation code, press the key UP or DOWN to select “y” (means
ON) or “no “ (means OFF). N = NO, Y = YES.
Press the key ENTER to save the selected function and configuration. If the display is showing “y”,
then the setting has been enabled. In the same way, if it was showing “n” when you pressed ENTER
The Red LED will flash during this operation.
SETUP OPTIONS - PROJECTOR CONFIGURATION
