INSTALLING THE PROJECTOR
280mm
BRACKET
106mm
BRACKET
BRACKET
BRACKET
Pass safety fixing
through these holes
The projector should be mounted via its bracket using 2 x M12 bolts. The brackets attach to the
underside of the projector with 4 x M8x25 bolts provided. Always ensure that the projector is firmly
anchored to avoid vibration and slipping whilst functioning. Always ensure that the structure to which
you are attaching the projector is secure and is able to support a weight of 19Kg for each PILOT 250.
For safety the projector should have a secondary fixing with a safety chain through the holes on the
underside of the unit.
WARNING
: The projector should NEVER be lifted or carried by the yoke.
FITTING THE LAMP
LAMP ACCESS
HATCH
SCREW
A,B AND C.
LAMP ALIGNMENT SCREWS
LOOSEN THE 2 x M4 SCREWS
LAMP BRACKET
PULL OUT THE LAMP BRACKET
TO ACCESS THE LAMP
LAMP
Undo the screw on the lamp access hatch, and then remove the hatch as shown in the above figure.
Undo the 2 x M4 screws (one on each side of the lamp bracket) and then pull out the lamp bracket
with the old lamp.
Pull out the old lamp and then plug in the new lamp. Do not touch the glass of the lamp with bare
hands.
Replace the lamp bracket and fasten the screws, then replace the lamp access hatch and fasten the
screw.
The MSD series are high pressure lamps with external igniters (
). Care should always be taken
when handling these lamps. Always read the manufacturers "Instructions for use" enclosed with the
lamp.
PILOT250manualEN.doc
4/16
