INDEX
SECTION
PAGE
SAFE
USAGE
OF
THE
PROJECTOR
3
INSTALLING THE PROJECTOR
4
FITTING THE LAMP
4
POWER
SUPPLY
–
MAINS
5
CONTROL
CONNECTIONS
5
XLR CONNECTORS
5
5-PIN
AND
3-PIN
CONVERSION
5
DMX TERMINATOR
6
SETUP
OPTIONS
–
PROJECTOR
CONFIGURATION
6
SETUP OPTIONS TABLE
7
PROJECTOR
DMX
START
ADDRESS 8
DMX
CONTROL
CHANNEL
FUNCTIONS 8
STAND-ALONE MODE
9
CHANGING THE GOBOS
10
MAINTENANCE
10
LUBRICATION
10
KEEPING
THE
PROJECTOR
CLEAN
11
TROUBLESHOOTING
11
TECHNICAL
DATA 12
ELECTRICAL DIAGRAM
13
COMPONENT
ORDER
CODES 14
CHANGING OPERATING VOLTAGE AND FREQUENCY
15
Please note that as part of our ongoing commitment to continuous product development, specifications are subject to change
without notice. Whilst every care is taken in the preparation of this manual we reserve the right to change specifications in the
course of product improvement. The publishers cannot be held responsible for the accuracy of the information herein, or any
consequence arising from them.
Every apparatus is tested completely and packed properly by the manufacturer. Please make sure the packing and / or the
apparatus is in good condition before your installation and use. Should there be any damage caused by transportation, consult
your dealer and do not use the apparatus. But any damage caused by improper use will not be assumed by the manufacturer
and / or dealer.
THESE ITEMS ARE PACKED TOGETHER WITH THE PROJECTOR
ACCESSORIES
Mounting Bracket (2 PCS)
M8x25 screw for mounting brackets (4 PCS)
Power-cord (1 PCS), XLR plug (1 PCS), XLR socket (1 PCS), Safety cord (1 PCS)
Spare gobos (4 PCS)
This manual (1 PCS)
INTRODUCTION
Thank you for purchasing our product PILOT 250, PR-2250.
This product manual contains important information about the safe installation and use of this projector.
Please read and follow these instructions carefully and keep this manual in a safe place for future
reference.
The PILOT 250 is an innovative projector with an elegant housing, which is made from high intensity
and heat–resistant complex plastic. The product complies to CE norms and standards and uses
international protocol DMX 512. It can be used as a stand-alone unit or linked to a controller, so it is
suitable for many different applications.
The PILOT 250 features 9 colours plus white on the colour wheel, 2 gobo wheels, one with 7
indexable, interchangeable rotating gobos, one with 7 interchangeable fixed gobos. DMX controlled
focus, a 3 facet rotating prism and 3 beam angles. The prism channel also has pre-programmed
“macros” giving automated selection of prism and gobo combinations for easy programming and
operation. The pan and tilt motor speeds are adjustable, the lamp may be switched on and off
remotely and the unit may also be reset remotely. The pan and tilt have encoder wheels allowing auto
position correction. A 2 blade shutter provides dimming and strobe effects.
PILOT250manualEN.doc
2/16
