Pure Reliability PANDA II PR-2100B, Руководство по эксплуатации продукта

Страница: 4 / 12

INSTALLING THE PROJECTOR
4/12
panda II manual.doc
There are two ways to install the projector either hanging the projector from the ceiling or sitting on the
floor.
Mount the inner and outer brackets provided on the body of the projector. There are 2 M8 knobs
provided to tighten the body of the projector and the two brackets. When you want to adjust the angle
of the body of the projector, you only loosen the two M8 knobs carefully and then adjust the angle of
the body. After finishing that, it is recommended that you don’t forget to retighten the two M8 knobs.
Always ensure that the projector is firmly positioned to avoid vibration and slipping. For suspending the
projector always ensure that the structure to which you are attaching the projector is secure and is
able to support a weight of 6kg for each PANDA II.
FITTING THE LAMP
Remove the upper cover by loosening the 2 M4 taping screws and 1 M4 knurling screw.
Insert an EFR 15V/150W lamp in the lamp porcelain holder. (When replacing a lamp, you should
first pull out the old lamp from the lamp-bracket.)
Push the lamp into the position seat of the lamp-bracket carefully.
Install the upper cover again. (
Note:
Do not forget to connect the grounding-cord with the upper
cover.)
Retighten the 2 M4 screws and 1 M4 knurling screw.