Pure power tolls 10.8V Li-ION, Оригинальное руководство пользователя

Страница: 8 / 12

8
c. To remove the Battery Pack, simply press
the two locking tabs with your finger and
thumb and withdraw the Battery Pack from
the handle.
2. ON/OFF TRIGGER SWITCH
This tool is fitted with a variable speed
trigger switch that delivers higher speed and
torque as the trigger pressure is increased.
The trigger switch is also fitted with a brake
function which stops the chuck immediately
when you quickly release the trigger.
3. TRIGGER SWITCH LOCK
To lock the trigger switch in the OFF position,
slide the forward/reverse selection control to
its central position.
4. FORWARD/REVERSE SELECTION
For drilling and screw driving use the
forward rotation marked ► on the selection
lever. Push the lever fully to the right.
For reverse rotation, necessary when
removing screws etc, push the selection
lever fully to the left. Marked ► on the
selection lever.Only operate the selection
lever when the drill is at a complete stop.
5. CHUCK OPERATION
This drill is equipped with a self centering
three jawed keyless chuck.
a. To open the chuck jaws, rotate the front
section of the chuck.
b. Insert the required drill bit or screwdriver
bit into the open chuck jaws and rotate the
front section of the chuck in the opposite
direction to close the jaws around the bit
c. Hold the rear section of the chuck, and
rotate the front section of the chuck firmly
to secure the drill/screwdriver bit into the
chuck
.
d. Rotate the chuck by hand to check that
the bit is centrally located in the chuck.
6. TORQUE ADJUSTMENT
Torque is the rotary force that the drill can
deliver. This drill has a 24 position torque
adjustment ring.The higher the number the
torque adjustment ring is set at, the greater
the torque delivered by the drill.
For guidance:
1-4 for driving small screws
5-9 for driving screws into soft material
10-15 for driving screws into soft and
hard materialsfor sustained heavy drilling
(maximum torque)We recommend that the
operator trials any torque application by
starting with a low setting. Progressively
increase the torque setting until the desired
outcome is achieved.
7. THE LED LIGHT
The LED light works automatically when
the trigger switch is depressed. This
feature is useful when using the drill in
lowlight situations.
8. DRILLING METAL
1. For maximum performance, use High
Speed Steel (HSS) drill bits for metal or
steel drilling.
2. Use a centre punch to mark the hole
location on the workpiece.
3. Turn the torque adjustment ring to a
suitable setting.
4. Secure the workpiece in a vice or other
clamp if practicable before operation.
5. Begin drilling at a low speed to prevent
the bit from slipping out of the centre punch
indentation.
6. Maintain a speed and pressure which
allows efficient cutting without overheating
the bit. Applying too much pressure could
overheat the drill bit, and lead to premature
wear of the machines bearing etc.