8
PARTS
ASSEMBLY
ASSEMBLY ON WALL
- Pay attention to distances defined in the picture while
mounting device on wall.
- Screw wall connection tools by stretching on the product
that you will find inside of the packing.
- Connect the body fasteners in the holes of the product
with the plastic-headed screws.
- Fix the wall fastener with the ones of the body already
fixed in the product with the screws and wing nuts.
- Finally, hang the product on the wall.
The device must be completely parallel to the floor.
Electrical connection required for wall mounting (if it
is operated without any cable) must be performed by
authorized service employee.
Please consider the following warnings for electrical
connection required for wall mounting without any cable.
Electrical connection: Insert the plug into socket by paying
attention to marks “L” and “N”. Connect to the grounded
plug for you own safet. Then adjust the heater upwards.
Find the best angle and tighten the screws.
Never operate your infrared heater in vertical position.
After your infrared heater is mounted on wall, rotation
angle is limited to 35º.
In order to angle your heater just like in the picture, you can
define angle of the heater by loosening butterfly nuts and
tightening screws on wall mount part.
1- Grill
2- Special metal profile side lids
3- Plastic side lids
4- Reflector
5- Thermostat knob
6- Heater component tube
Allen screw
Buttterfly nut
Plastic.headed
screws
Body
fastener
Wall
fastener
1
4
2
3
6
5
