
6 (15)
K 101/151/200/250/300.58.0404.Eng/Digital
SERVICE INSTRUCTION
K 101, 151, 200, 250, 300
Oljeavtappning
Motor
Oljepåfyllning
○
○
○
○
○
○
○
DISASSEMBLING
Removal from the Wet Well
Hoist the pump from the sump and rinse it clean.
Disassembling the Volute
The motor unit is connected to the volute with six
bolts. Loosen the locking screws, turn the latch bolts
90
o
and lift off the motor unit from the volute.
(Fig. 1-2)
Adding and Changing the Oil
The oil housing of PUMPEX wet pit pumps is filled
with oil at the plant.
Type of Oil:
White Oil (e.g. Enerpar M002 or Similar).
Oil Amount:
4 dl (0.9 US pints)
F - T – P installation
5 dl (1.1 US pints)
H - installation
Remove the plug marked ”oil out” and slant the pump
slightly forward. Let the old oil pour out through the
groove under the plug. Then loosen the plug marked
”oil in” to facilitate the oil draining out. Gather the old
oil in the can. Fasten the plug so that the lower, not
the top O-ring gasket becomes sealed.
Fill new oil in "oil in" and fasten the plugs.
Inspect the motor housing to see if it is dry by
removing the screw marked ”motor”. Tilt the pump
slightly. If water, oil or other debris is present in the
motor housing, a full dismantling is required. (Fig. 3)
Fig 1
Fig 2
Fig 3
QuickLock
TM
Latch Bolts
Oil filling
Oil out
Motor