EN
67
6 Quick start
6.1 Parameter settings
6.1.1 FC setting for single pump
Normally, all necessary input and output sensors (transducers) will be connected. When wiring the pump, the
electrical connection to the triangle (3x230 V) must be made.
After switching on the FC, long press the "+" or "-" button for 3 seconds to enter the pressure setting mode. Set the
desired pressure "d" and then press the "START/STOP" button to save the set pressure parameter. Now press the
"START/STOP" button again to start the pump. Now the pump with FC will operate in normal working mode.
P0.14 = 1 Auto start function on switch-on (factory setting set to P0.14 = 0)
6.1.2 FC settings for multiple pumps
It is possible to connect up to 5 pumps in one system (each pump must have its own FC).
Electrical connection: connect all "S +" terminals and all "S -" terminals in parallel with each other.
Use the following table to quickly set up your system (Macro Settings - parameter F-47)
.
System type
Controlling
FC
(Master)
1. Auxiliary
FC (Slave)
2. Auxiliary
FC (Slave)
3. Auxiliary
FC (Slave)
4. Auxiliary
FC (Slave)
5. Auxiliary
FC (Slave)
1 Frequency convertor in the
system
F0-47=1
2 Frequency convertors in the
system
F0-47=2
F0-47=11
3 Frequency convertors in the
system
F0-47=3
F0-47=11
F0-47=12
4 Frequency convertors in the
system
F0-47=4
F0-47=11
F0-47=12
F0-47=13
5 Frequency convertors in the
system
F0-47=5
F0-47=11
F0-47=12
F0-47=13
F0-47=14
6 Frequency convertors in the
system
F0-47=6
F0-47=11
F0-47=12
F0-47=13
F0-47=14
F0-47=15
Emergency mode
F0-47=9
