Model: RM1-15
Receptacle Module
Installation Guide and
Owner’s Manual
The Inventors Of:
19201 Parthenia St. Suite J
Northridge, CA 91324
P: 818.701.9831 F: 818.701.1506
[email protected] www.pcslighting.com
FUNCTION
The RM1 is ideal for remotely controlling one or more
120VAC non-dimming appliances with a maximum rating of
15 Amps. The RM1 will replace any standard wall outlet, the
top outlet is controlled. No additional wiring is required. Its
lower outlet allows vacuums, computers, and other devices
that do not require remote control to be plugged in to the
normal electrical circuit.
UPB controllers and modules can be freely located anywhere
throughout the home. No additional wiring is required and
no radio frequency signals are used for communication.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic safety precautions
should always be followed, including the following:
1.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
2.
Keep away from water. If the product comes in contact
with water or other liquid, turn off the circuit breaker
and unplug the product immediately.
3.
Never use products that have been dropped or damaged.
4.
Do not use this product outdoors.
5.
Do not use this product for other than its intended
purpose.
6.
Do not connect multiple lamps or appliances that, when
combined, exceed the maximum load ratings of the
product.
7.
To avoid any risk of fire, burns, personal injury or electric
shock, install this product out of the reach of small
children.
8.
Do not cover this product with any material when in
use.
9.
This product uses grounded plugs and sockets to reduce
the risk of electric shock. These plugs and sockets fit
only one way. If they do not fit, consult an electrician.
10.
SAVE THESE INSTRUCTIONS.
INSTALLATION
The Receptacle Module is designed for indoor use with devices that
plug into a grounded power outlet. To install the RM1 module:
1.
Disable circuit supplying power to outlet at the circuit breaker or
fuse panel.
2.
Remove the existing wall plate and outlet
3.
Label wires connected to existing device.
4.
Disconnect existing device.
5.
Strip wires have a length of ½” of bare wire.
6.
Install device per wiring diagram below.
7.
Torque terminal screws to 12-14 inch-pounds
8.
Mount the receptacle in to the wall box.
9.
Attach wall plate, and then restore power to the circuit.
10.
Plug the controlled device into the top socket on receptacle
module. The appliance/device current rating must not exceed 15
Amps.
11.
Turn the device’s power switch to its ON position.
If desired, another device can be plugged into the bottom outlet of
the receptacle module, which is always powered.
CAUTION
: Do not insert metal objects into the module while it is
connected to power.
