6
Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call (866) 434-6067.
Assembly
Charging the Battery
WARNING:
Battery must be fully charged before you ride your electric scooter.
Required components: battery charger
• Initial battery charge time - 12 hours
• Recharges after initial charge - up to 10 hours
• When scooter is not in regular use batteries need to be charged on a monthly basis to maximize performance
1. Make sure power switch is in the OFF
position before plugging in the charger. Insert
charger into charging port on the right side of
the battery box.
2. Plug the battery charger into a wall power
outlet. The light on the charger housing
should illuminate. Red LED light indicates
battery is charging and a green LED light
indicates battery is fully charged.
WARNING:
instructions may damage your product and void your warranty.
Note: Do not store the battery in temperatures above 70˚F (21˚C) or below 32˚F (0˚C).
Note: The charger has a small window with one LED light that indicates the charge status. Refer to the illustration on the charger unit for
the actual “charging” and “charged” status indication. Your charger may get warm during use; this is normal and is no cause for concern.
Note: Batteries must be recharged at least once a month even when the scooter is not in use. Failure to do so may result in batteries that
will no longer accept a charge.
FCC instruction for Battery charger:
the party responsible for compliance could void the user’s authority
to operate the equipment.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna. --Increase the
separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit di
fferent from
that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
WARNING:
compliance could void the user’s authority to operate the equipment.
