www.pulsar.pl
INTU
5
3. Configuring the connection in the PowerSecurity program.
The “PowerSecurity” program can be downloaded at:
http://www.pulsar.pl/pliki/PowerSecurity.exe
1. Run the PowerSecurity program.
2. Choose the Power Supplies > New Power Su
pply option from the menu bar. The “Configuration of
connection” window, that allows configuring the settings, will be displayed. Enter the same settings as in
the picture below.
The power supply units of the EN54 series allow higher transmission speeds - instead of 19.2k 8E1 it
can be set to 115.2k 8E1. The changed values apply to all settings.
Fig. 4. The connection configuration window
.
PSU
Description
Name
The name of the PSU
The name that should be assigned individually to each PSU.
Address
1 ÷ 247;
Enter the address assigned to the PSU in the RS485 bus
Refresh period of
the preview [ms]
100 ÷ 60 000ms;
Refresh period of the parameters in the preview window.
CONNECTION
Type
Modbus RTU
Port
Enter the COM port number the same as assigned in the device manager, or select
AUTO for automatic assignment
.
Transmission
speed
Max 19 200 bauds
– PSU of the PSBEN series
Max 115 200 bauds
– PSU of the EN54 series
Parity check
Parity
Response time [ms]
100 ÷ 60 000ms;
The response time from the power supply
The interval
between the
transmissions [ms]
The minimal interval between transmissions.
The number of
retransmissions
The number of retransmissions after which the program reports a connection error.
