Pulsar PWG2700VE, Руководство оператора

Страница: 24 / 27

2
4
PROBLEM CAUSE SOLUTION
Engine does not start 1. Out of fuel 1. Fill fuel tank
2. Engine oil low 2. Add engine oil
3. Spark plug wire disconnected 3. Connect spark plug wire
from spark plug 4. Replace spark plug
4. Bad spark plug 5. Contact service center
5. Spark plug wire has shorted 6. Contact service center
6. Ignition inoperative
Engine hard to start 1. Stale fuel or water in fuel 1.
2. Spark plug producing weak spark gasoline.
3. Excessively rich fuel mixture 2. Contact service center
3. Contact service center
Engine lacks power and vibrates
1.
1.
excessively
Engine quits during operation 1. Out of fuel
1. Fill fuel tank
Engine loses power when load is
1. Engine speed is too slow
1. Move throttle to fast. If this does
added not correct problem, contact
service center.
Water pressure is wea k 1. Water supply is restricted. 1. Inspect garden hose for kinks or
2. Water not turned on to full power leaks. Make sure you are using
3. Not using high pressure nozzle a large enough garden hose
(min. ¾ inch diameter)
2. Open water source all the way.
3. Change nozzle
Detergent and spray do not mix
1. Detergent hose is not submerged 1. Make sure hose is connected
or has disconnected and submerged in the detergent.
2. Black soap nozzle needed 2. Install soap nozzle
TROUBLESHOOTING
Engine can't normally stop
1. The pressure washer is run out of
power.
2. It is normal when we starting the
pressure washer. It is run out of
power when we want to stopping it.
3. It is normal when we starting the
pressure washer, but it is broken
when we want to stopping it.
1. Please pull the recoil starter to
starting it. Push switch to the stop
position for 6 seconds to stopping
the machine.
2. Please push switch to the stop
position for 6 seconds to stopping
the machine.
3. Please push switch to the stop
position for 6 seconds to stopping
the machine.