Pulsar PWG2700VE, Руководство оператора

Страница: 17 / 27

OPERATION
1
7
Pre-Operation Check List
• Read and understand this operator manual in its entirety before operating pressure washer.
• Check oil level and add oil to the proper level if low.
• Check connections of handle and all hoses to make sure they are secure.
• Check all hoses for kinks and damage.
• Check flow of water supply and make sure it is adequate (40 - 80PSI).
Starting Pressure Washer (See Fig
9
-1
0
)
• Place pressure washer on a level surface.
• Turn on water.
• Attach wand/lance to spray gun.
•
Purge the system’s pump of air by releasing the safety and squeezing the trigger of the spray gun.
•
Press the battery switch to "ON". Press the start button for 3 seconds to rouse starting process, the start button will
lighten.
•
Then press the start button for 1 second again to start the engine.
FIG
9
FIG 1
0
CAUTION!
Do not run pressure washer with a damaged hose. Do not run pressure washer without
result. FAILURE TO FOLLOW THESE INSTRUCTIONS WILL VOID PRODUCT WARRANTY.
WARNING!
from dissipating.
• Carbon monoxide gas is a poisonous, odorless gas that can cause headache, confusion, fatigue, nausea, fainting,
sickness, seizures, or death. If you start to experience any of these symptoms,
IMMEDIATELY get fresh air and seek
medical attention.
•
•
• When working in areas where vapors could be inhaled, use a respirator mask according to all of its instructions.
ENGINE
STATR
STOP